GUIDE TO BUYING A VOLVO 140 = 1966-1975
The Volvo 140 was really the first of the Volvo cars to become
available to the man in the street, as a family saloon, sold
on the promise of being safe, solid and reliable, it quickly
gained a very strong foothold in the UK Market as specious family
transport. The Volvo 140 was the forerunner of today’s
240, 740 and ultimately the 940 series cars, being a natural
progression over the years from those early cars.
The 140 Series is still held in high regard by many people,
being a popular car for rallying, and a favorite with many for
a classic car, the price being well within most peoples reach.
The ‘Tax Exempt’ status of all cars built before
the 31 st December, 1972 has also helped this car achieve classic
status.
The 140 Estate Car, known as the 145, has always been a very
popular car because of its enormous load capacity. Today, good
examples are hard to find, as most have been so well used for
what they were intended, that they are beyond restoration and
have been scrapped.
The 142, a 2 Door Saloon version, was primarily made for the
foreign markets, and only available here as a special order,
and only until 1971.
The 145 Estate and the 142 are the rarest of the 140 Series,
with the Estate demanding the most money, especially if manual.
==================================
GENERAL:
The first cars to be imported into the UK arrived in 1967;
nearly twelve months after the 140 made its debut at the 1966
Motor Show. It was billed as the replacement for the aging 120
Amazon but in fact sales of the 120 continued at a steady rate
and production ran along side the 140 until it finally ceased
production in 1970.
Powered by the well proven B18 1778cc, 4 cylinder engine as
used in the 120 and 1800 models, the car came in three variations
that were identified by a simple numbering system. The first
number – the model, second number – the number of
cylinders in the engine and thirdly – the number of doors
and finally any special features. Models were the 144 – a
4-door saloon, 142 – a 2-door saloon and the 145 – a
five-door estate. ‘S’ was added to some models e.g.
144S which denotes the vehicle was fitted with the twin carb
higher performance engine. Other models were: ‘DL’ the
base model, ‘GL’ higher specification interior etc, ‘E’ and ‘Grand
Luxe’ had the B20 fuel injection engine and there was also
a ‘GT’ in other markets.
In 1968 the B18 engine was replaced by a larger B20 unit of
1986cc and the one-piece aluminium grille gained a B20 Badge.
Externally the 140 remained the same with only minor alterations
to the trim.
The new model for 1970 saw improvements, which included head
restraints and improved through-flow ventilation. The 145 up
to 1971 had opening rear side windows, which today is a very
rare model to find.
For 1971 the 140’s wheelbase and radiator
capacity increased. Outside the car sported a new grille of three
piece design and air vents were added to the front valance below
the bumper. Wheel size was increased from 4½ J to 5J in
width. New for 1971 was the fitting of the B20E injection engine
from the 1800 into the Grand Luxe model, with overdrive fitted
as standard on manual transmission. Nearly all were Metallic
Gold with Black leather interior’
The 140 of 1972 had flush door handles fitted
to the outside. A shorter sporty type stick replaced the long
gear lever and a new style dash was fitted.
With new safety laws in the USA Volvo in 1973
fitted new larger bumpers, new grille, rear light assembly and
repositioned the front indicator lights on to the side of the
front wings. Internally the car gained childproof locks on the
rear doors.
The cars of 1974 were the last year of production.
The front door windows lost their opening vents and the size
of the bumpers grew to meet further USA Regulations, which included
the fitting of shock absorbing mountings to the bumpers. Injection
models of 1974 were fitted with the K-Jetronic Fuel Injection
System. All engines were fitted with the B20 'Big Valve' cylinder
head and the crankshaft was of the 8 bolt type. This engine had
many of the design features and parts that would be found in
the B21 and B19 engines that would be used in the 240 and 360
models which would replace the 140.
Volvo also, not for the UK market,
produced a high top version of the 145 Estate called the ‘Express’.
These were popular with Volvo Agents in Europe as Service Vehicles.
They also produced a van with solid rear sides – again
not for UK market.
INSPECTION:
The B18 engined 140’s are today much sort after but parts,
particularly trim are becoming difficult to find in new or excellent
second-hand condition. If you decide to buy a B18 140 to restore
make sure you examine it carefully before you take it on. Front
wings for early cars are still available but new front panels
are now difficult to find. Later panels can be fitted but have
different lower air vents in the front valance and holes for
the bumper irons.
All 140 series vehicles are collectable
but the 145 and 142, in good condition, usually command a higher
price than the 144 saloon. The twin carb ‘S’ models
both estate and saloon are much prized and overdrive, where fitted
to manual gearbox models, is very desirable. Early 145’s
had opening rear side windows, these models are extremely rare
and collectable.
140 BODY PROBLEM AREAS:
Rust is not a major problem with the 140 series. The cars are
well rust proofed from new. The underside of the car being heavily
undersealed and if checked regularly should provide excellent
protection against rust.
When purchasing a 140 Series one should however remember that
these cars are at best over 30 years old and some over 40 years
of age. However despite their age fortunately the 140 does fair
better that most other vehicles of the same age.
Rust does however appear in the following areas:
Front Wings:
Front wings on all 140 cars are prone to rust particularly
around the headlight and sidelight. Look also along the top edge
where the wing is bolted into position. Wings are still available
new and can be replaced easily as they are bolted onto the main
bodyshell.
Front Panel :
Rust is very common in this panel in the area around the sidelight.
Make sure there is a seam where the two panels join (Front Wing
and Front Panel). In rusty cars this is often filled in with
filler and no physical groove where the two panels join can be
seen (See Fig: 1). Check also the condition of the bonnet slam
panel around the lock.
Radiator Crossmember:
Rust does appear in this chassis section. Check particularly
the front sections behind the front valance. The rear of the
member can be rust free due to splashed oil from the engine,
while the front section has totally disappeared.
Inner Front Wings:
Rust in this area is extremely common. Purchasers should check
this area with care particularly around the bonnet hinge mountings.
A repair panel is available but requires welding into position.
Check also the front end of the inner wings where they meet the
front panel and the top rails where the wings are bolted onto
the car.
Bulkhead:
Look for rust in top corners under the bonnet.
Front Scuttle (area below front windscreen):
Rust appears at the two extreme ends of the panel between the
windscreen and the front wing. Repair of this area can be expensive
as it requires both the windscreen and the front wings being
removed.
Front and Rear Windscreen:
Rust can be found around both these areas. Pay particular attention
to ANY rust, which appears to be coming from under the windscreen
rubber. It is common to find large holes behind the seal due
to corrosion when the windscreens are removed.
Bonnet:
Look for rust in the front edge.
Doors:
Generally 140 doors are long lived, however rust does affect
the lower section of the skin and frame. Look also for rust around
lock mechanism. Doors from the 142, the 2 door car doors are
particularly difficult to find second hand but the club is able
to help locate any parts that a member may require.
Sills:
Sills generally are good but rust is common in the rear portion
where they meet the rear wing.
Rear Wings:
Check condition of both inner and outer wheel arches. Repair
panels are available for the arch edge and are reasonably priced.
Check also the inner wheel arch inside the boot. This is where
the top of the rear shock absorber is mounted and rust can affect
this area.
Boot:
Rust is very common in the two wheel wells on either side of
the boot floor. Repair panels are available.
Boot Lid:
Check edge of boot lid.
145 Tailgate:
Rust in the lower portion is common. Good second hand tailgates
are getting hard to find. Later 240/260 gates will fit.
Rear Axle Mounting Arms:
Rust can appear in the pressed arms used to mount the rear
axle. Check condition, replacements could be expensive.
The above is only a guide to rust problems in 140’s.
Care should be taken to check all parts of the car but do remember
that all of these cars are over 30 years old and some 40.
TO SUMMERISE – MAIN AREAS OF RUST:
Around Headlight and Side light - front wings
Front Panel where it joins wings.
Top on front wings
Bottom of Doors – Skin and frame
Sills – Rear portion.
Wheel arches, front and rear
Boot floor – Both spare wheel wells
Front edge of bonnet
Crossmember under radiator – check front edge
Inner front wing – tops of inner wing and is where bonnet
hinges are mounted
Rear Tailgates – Estate Models
Ends of front scuttle (Panel below front windscreen)
Rust can appear around windscreens
OTHER PROBLEM AREAS:
Injection parts for Injection Engined models are expensive
new, hard to find second-hand
Interior hard to find in good second-hand condition, particularly
front seats
Some chrome trims no longer available new.
Time Clocks on all models rarely work but can be rebuilt
OTHER POINTS TO REMEMBER/CHECK:
Engine:
ALWAYS check that the car is fitted with a Genuine Volvo Oil
Filter, other makes can cause problems with engine lubrication
if they do not have the non-return valve fitted in them. A Volvo
B18/B20 engine should cover over 200,000 miles without major
rebuilding – although camshafts, valve guides and fibre
timing gears may need replacement at around 100,000 miles.
Camshafts on injection engines are particularly prone to wear
at around 100,000 miles and can be mistaken by unskilled ears
as Crankshaft Big End Bearing failure, more skilled enthusiasts
will note the sound is only half engine speed – hence valve
area. Fibre timing gears can be replaced with all steel gear
sets – originals are one fibre, one steel. The originals
are fine and give no problem but if you intend to up-rate the
engine with a high lift cam etc, steel gears are a must.
Engines with high mileage’s can smoke particularly on
start up of on over-run down hill. This will generally be caused
by valve guide wear and oil running down valve into combustion
chamber.
B18 and B20 can be converted to run on unleaded. Original Valves
fitted are already hard (Stellite) but valve seats will have
to be replaced – Unleaded head conversions are though the
Club.
Manual Gearbox:
The manual gearbox fitted to the 140 is robust, long lived,
and should not cause any real problem. When driving cars it is
best to ‘slip the clutch’ when engaging and dis-engaging
overdrive. This helps to give a smooth operation and avoid damage
to components. The use of the wrong oil can cause problems – Gear
oil should never be used in gearboxes with overdrive. Oil is
shared by the two units – checked and filled in the Gearbox.
Manual Gearboxes without Overdrive use Gear Oil. Check Workshop
Manual for Oil Grades. Overdrive Gearboxes are often found second
hand. Reconditioned Overdrives and Spares are available through
the Club.
Auto Gearbox:
The Automatic Gearbox fitted to the 140 was made by Borg-Warner
and gives little trouble. However if the vehicle has stood for
a long period it may be worth having the box fully checked and
serviced before use.
Rear Axle:
The rear axle is again almost indestructible, however, loss
of oil can cause premature failure. Check for oil leaks around
the pinion bearing seal (where prop shaft bolts to axle). It
is common on higher mileage cars to encounter differential whine,
but this does not mean that the axle will not give further long
service.
Brakes:
All 140 Series vehicles have disc brakes all round – the
handbrake is operated by brakes shoes mounted in a drum in the
centre of the rear discs. All are very reliable but Brake Calipers
on rear are prone to seize particularly if vehicle is left for
long period in damp conditions. Both ATE and Girling Brakes were
used – check which your vehicle has before ordering any
parts, as they are different. Brakes are twin circuit.
Engine Types Fitted to UK Spec Vehicles:
B18A – 1778cc Single Carburettor – Fitted
to 142, 144 and 145 to 1968
B18B – 1778cc Twin SU Carburetors – Fitted
to 142S, 144S and 145S to 1968
B20A – 1986cc Single Carburettor – Fitted
to all single carb models
B20B – 1986cc Twin SU or Stromberg Carbs – Fitted
to all twin carb models
B20E – 1986cc Bosch Jetronic
Fuel Injection – Fitted
to all injection models.
BUYERS PRICE GUIDE VALUES: £50 - £4,500+
For Restoration:
For a car to use as a basis for a total restoration £50
- £150
Running but require work:
Running but in need of some major work in near future e.g.
Sill replacement-
£150 - £500
Cars generally in good condition:
Cars generally in good condition but may need minor work to
improve appearance – good useable car with no major faults
or corrosion £500 - £1,500
The Best Cars:
The best cars – not concours but having only minor faults £1,500 – £3,500
Be prepared to pay up to a £1,000 more for an Estate
The Very Best Cars – Concours Winners & Rebuilt:
Cars, which have been fully restored or are Concours standard,
start at around £3,500+ depending on all round condition
of the vehicle. Interior, chrome, originality, and low mileage
will add to the price, as does documented history of the car,
original bill of sale etc.
VOLVO ENTHUSIASTS CLUB SPARES SERVICE:
The Volvo Enthusiasts Club has a spares service which offers
a wide range of Genuine, alternative and reproduction 140 parts
to Members, Tel: 01425 476425 and provides Technical Information
on other models.
COPYRIGHT:
Please Note: This Buyers Guide is produced
by Kevin Price and is the Copyright of the Volvo Enthusiasts
Club. No part of this publication may be reproduced in any form
without prior permission, in writing from:
Kevin Price, Volvo Enthusiasts Club, 127 Kidderminster Road, Bewdley, Worcs. DY12 1JE |